UK Audi Forum banner
1 - 11 of 11 Posts

· Registered
Joined
·
62 Posts
Hi there,

The 210's and 225's go to a similar level when remapped. I would say conservatively they go up to around 250bhp as a standard car. I'd recommend doing at least a panel filter which will help the car breath a lot better. If you were then to go for a full turbo back exhaust with a 3'' downpipe and cat etc you could then go for stage 2 software which increases the bhp again but gives a great increase in torque.

We do the APR remaps and there should be an APR dealer close to you. Where abouts are you from?
 

· Registered
Joined
·
4 Posts
Discussion Starter · #5 ·
well thats not good, that'll be the next upgrade £££. i've got a standard ARZ engine with a complete everything s3 set up from a APY engine twin coolers mainfolds etc etc the lot no map yet played about and got 253bhp from a standard engine on AMD rollers. so i might have to get a trial to see if it makes any differents to power gains
 

· Registered
Joined
·
15 Posts
hi, im new to to all this... whats TIP? iv just bought an s3, it had a superchip remap, then had a Milltek sports cat and cat back exhaust... would you recommend a stage 2 remap to get better gains from the milltek? and if so, anything else i should be uprating before i do this (other than fmic coz its too expensive lol) i live about 10mins from awesome gti.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top